Quick Arm; Quick Exit; Fire Safety In The Home; Household Fire Safety Audit - DSC SYSTEM MASTER PC4000 Instruction Manual

QUICK ARM

[ ]+[0]
Entering [ ][0] is accepted as a valid arming code when the "Quick Arm" feature is
activated. This command is often used when individuals are required to arm the
system but not disarm it. This could be used with home visitors in the case of a
residential alarm or junior employees and maintenance staff in the case of a
commercial alarm. See instructions in the "[ ][6] Users Programming Commands"
section for activating the "Quick Arm" feature. Users with a one-time use access code
should not use this feature, because the one-time use code is only erased when it is
used to arm the system.

QUICK EXIT

[ ]+[0] WHEN ARMED
Entering [ ][0] when the system is fully armed will allow the user 2 minutes to exit the
premises through any delay zone without altering the status of the system if the "Quick
Exit" feature is enabled. After [ ][0] is entered into an armed system, one and only one
delay loop may be tripped. Any additional activity on any other active loop will cause
that loop to begin its alarm sequence. Quick exit activation will be logged onto the
event buffer.

FIRE SAFETY IN THE HOME

Most fires occur in the home and to minimize this danger it is recommended that a
household fire safety audit be conducted and a family escape plan be developed.

HOUSEHOLD FIRE SAFETY AUDIT

1. Are all electrical appliances and outlets in a safe condition e.g. frayed cords,
over-loaded lighting circuits? If you are uncertain about the condition of your
electrical appliances or household service, have a professional evaluation.
2. Are all flammable liquids stored safely in closed containers in a well ventilated
cool area? Cleaning with flammable liquids should be avoided.
3. Are fire hazardous materials (matches) well out of reach of children?
4. Are furnaces and wood burning appliances properly installed, clean and in good
working order? Have a professional evaluation.
13