Installing Your Router; Hardware Installation - Draytek VigorIPPBX 3510 Series Quick Start Manual

2 . I n s t a l l i n
2 . I n s t a l l i n
This section will guide you to install the router through hardware connection and
configure the router's settings through web browser.
2 . 1 H a r d w a r e
2 . 1 H a r d w a r e
Before starting to configure the router, you have to connect your devices correctly.
1. Connect the cable Modem/DSL Modem/Media Converter to WAN port of router
with Ethernet cable (RJ-45).
2. Connect one end of an Ethernet cable (RJ-45) to one of the LAN ports of the router
and the other end of the cable (RJ-45) into the Ethernet port on your computer.
3. Connect the telephone sets with phone lines (for using PBX function). For the model
without phone ports, skip this step.
4. Connect IP Phone(s) via VigorSwitch to this router.
5. Connect one end of the power adapter to the router's power port on the rear panel,
and the other side into a wall outlet.
6. Power on the device by pressing down the power switch on the rear panel.
7. The system starts to initiate. After completing the system test, the PWR and ACT
LEDs will light up and start blinking.
(Below we take VigorIPPBX 3510 as an example for hardware installation.)
g Y o u r R o u
g Y o u r R o u
I n s t a l l a t i o n
I n s t a l l a t i o n
t e r
t e r
5
VigorIPPBX 3510 Quick Start Guide