Table of Contents
Advertisement
Frame Type
Status
Rate
Click OK to save the settings.
4
.
4
.
2
P
o
r
t
s
C
o
4
.
4
.
2
P
o
r
t
s
C
o
This page is used to configure the ACL (Access Control List) parameters for each port. These
parameters will affect data packets received on a port unless the data packets match a specific
ACE (Access Control Entry).
Available settings are explained as follows:
Item
Port
Action
Vigor1000 Series User's Guide
Set the Unicast storm rate control, multicast storm rate
control, and a broadcast storm rate control for your router.
Check this box to enable storm control status for the frame
type.
The unit is packet per second (pps). Use the drop down list
to set the rate for data transmission. The rate is 2^n, where n
is equal to or less than 15, or "No Limit". The unit of the
rate can be either pps (packets per second) or kpps
(kilopackets per second). The configuration indicates the
permitted packet rate for unicast, multicast, or broadcast
traffic across the switch.
n
f
i
g
u
r
a
t
i
o
n
n
f
i
g
u
r
a
t
i
o
n
Description
There is one WAN port and 4 LAN ports in Vigor1000.
Here each port will be configured with different ID, action,
rate limiter ID, port copy and etc.
Select whether forwarding is permitted ("Allow") or denied
("Deny"). The default value is "Allow".
99
Advertisement
Table of Contents
