Table of Contents
Advertisement
Auto-reconnect Delay
Keepalive
Keepalive Interval
Prefix Length
Interface
After finishing all the settings here, please click OK to save the configuration.
3
.
8
.
2
I
P
v
6
L
A
N
S
3
.
8
.
2
I
P
v
6
L
A
N
S
This page defines the IPv6 connection types for LAN interface. Possible types contain
DHCPv6 Server and RADVD. Each type requires different parameter settings.
Available settings are explained as follows:
Item
IPv6 Address
Link Local Address
Autoconfiguration Type
After passing the time set here, the client will retry to
connect in case of failure or keepalive timeout.
0 means not retry.
Check the box to keep the connection between TSPC and
tunnel broker always on. TSPC will send ping packet to
make sure the connection between both ends is normal.
Type the time for the interval between two keepalive
messages transferring from the client to the broker.
Type the required prefix length for the client network.
Display LAN interface name. The name of the OS interface
that will be configured with the first 64 of the received
prefix from the broker and the router advertisement daemon
is started to advertise that prefix on the interface.
e
t
u
p
e
t
u
p
Description
Type static IPv6 address for LAN.
It is used for communicating with neighbouring nodes on
the same link. It is defined by the address prefix fe80::/10.
You don't need to setup Link-Local address manually for it
is generated automatically according to your MAC Address.
The router provides one daemon for LAN side IPv6 address
configuration.
RADVD - The router advertisement daemon (radvd) sends
Router Advertisement messages, specified by RFC 2461, to
a local Ethernet LAN periodically and when requested by a
node sending a Router Solicitation message. These
messages are required for IPv6 stateless auto-configuration.
106
VigorFly 210 Series User's Guide
Advertisement
Table of Contents
