Dimplex DS4411 Owner's Manual page 9

Operation
turn the thermostat control
clockwise all the way to turn
on the heater. When the room
reaches the desired temperature,
turn the thermostat knob counter
clockwise until you hear a click.
Leave in this position to maintain
the room temperature at this
setting. For additional heat, turn
clockwise until you hear the click
again and the heater will turn on.
!
NOTE: When the heater
is switched on, the heater
fan will operate. The heater
element may or may not
be on, depending on the
thermostat control setting (see
"Heater Thermostat Control").
Resetting The
Temperature Cutoff
Switch
The heater is protected with
a safety device to prevent
overheating. Should the heater
overheat, an automatic cut out
will turn the heater off and it will
not come back on without being
reset. It can be reset by switching
the 3 Position Switch to oFF and
waiting five (5) minutes before
switching the unit back on.
CAUTION: If you need to
Figure 2
on
Button
oFF
Button
Insulator Strip
continuously reset the heater,
unplug the unit and call
Dimplex north america Limited
at 1-888-346-7539.
Remote Operation
The stove is supplied with an
integrated on/off remote control.
!
NOTE: Ensure that the
stove's 3 Position Switch is set
to the Remote setting (" ").
To operate, push the on button
to turn stove on, push the oFF
button to turn the stove
!
NOTE: Before attempting any
operation with the remote, pull
the plastic insulator strip out from
between the remote casing and
Battery Cover
(Figure 2)
off.
9