NOTE: Procedures and techniques that are considered important enough to emphasize. CAUTION: Procedures and techniques which, if not carefully followed, will result in damage to the equipment. WARNINg: Procedures and techniques which, if not carefully followed, will expose the user to the risk of fire, serious injury, or death. www.dimplex.com...
It can be reset by switching the MAIN ON/OFF Plastic SWITCH to OFF and waiting 5 minutes before switching Strip the unit back on. CAUTION: If you need to continuously reset the Battery heater, unplug the unit and call Dimplex North America Cover Limited at 1-800-668-6663.
Locate and examine the bulbs to determine which bulb(s) required replacement. Locate and remove the light bulb(s). Insert new bulb(s). Install the logset into the unit, pushing firmly against the glass. Replace the logset retaining screw into the ember bed. Close the door. www.dimplex.com...
LIgHT BULB REPLACEMENT Figure 4 CAUTION: If unit was operating prior to servicing allow at least 5 minutes for lights to cool off to avoid accidental burning of skin. WARNINg: Disconnect power before attempting any maintenance to reduce the risk of electric shock or damage to persons.
10 minutes for light bulbs and heating elements to cool off to avoid accidental burning of skin. WARNINg: Disconnect power before attempting any maintenance to reduce the risk of electric shock or damage to persons. Open door by pulling the handles. www.dimplex.com...
Remove the heater cover retaining screws located on Figure 8 the bottom of the stove and lower heater/light assembly onto the floor. Remove the reflector rod and motor assembly by removing the screws on the front and rear of the heater cover.
Page 10
Disconnect the heater wiring connections from the heater noting their original locations. Remove the 4 heater mounting screws and remove the heater from the unit. Reassemble in the reverse order as above. www.dimplex.com...
TROUBLESHOOTINg gUIDE PROBLEM CAUSE SOLUTION general Circuit breaker trips or fuse Short in unit wiring. Trace wiring in unit. blows when unit is turned on Improper circuit current rating Additional appliances may exceed the current rating of the circuit breaker or fuse. Plug unit into another outlet or install unit on a dedicated 15 amp circuit.
Page 12
Grinding or excessive noise with Moving flame rod hitting or rubbing Ensure rod is straight and mounted properly in the the heater off against internal components bracket, spinning freely away from other components. Replace if necessary. Defective flame motor Replace flame motor www.dimplex.com...