Operation - Dimplex DS7420 Service Manual

OPERATION

To access the controls, go to the back of the stove
1).
Figure 1
B
A
C
A. 3-Position Switch
The switch has two On positions marked with "I" and "II".
The "I" position is for manual operation. In this position the
built-in remote control is bypassed.
The "II" position is for operating the unit with the provided
remote control. When in "II" position the unit is operated
with the ON and OFF buttons of the remote control.
When the switch is in the center position "O" the unit is off.
B. Light On/Off Switch
The Light On/Off Switch supplies power to the upper light of
the log bed display area.
C. Heater On/Off Switch
The Heater On/Off Switch supplies power to the heater.
D. Heater Thermostat Control
To adjust the temperature to your individual requirements,
turn the thermostat control clockwise all the way to
turn on the heater. When the room reaches the desired
temperature, turn the thermostat knob counter clockwise
until you hear a click. Leave in this position to maintain the
room temperature at this setting. For additional heat, turn
clockwise until you hear the click again and the heater will
turn on.
Resetting the Temperature Cutoff Switch
Should the heater overheat, an automatic cut out will turn
the heater off and it will not come back on without being
reset. It can be reset by switching the 3-Position Switch to
Off "O" and waiting five (5) minutes before switching the
unit back on.
CAUTION: If you need to continuously reset the heater,
unplug the unit and call Customer Service at
1-888-346-7539.
(Figure
D
Remote Control
The stove is supplied with an integrated On/Off remote
control.
!
NOTE: Ensure that the stove's 3-Position Switch is set
to the Remote Control setting
To operate, push the ON button to turn stove on, push the
OFF button to turn the stove off.
Remote Initialization/Reprogramming
Follow these steps for Remote Control initialization and if
required, re-initialization:
1. Disconnect power to stove.
2. Set the 3-Position Switch to the Remote position "II"
(Figure 1A).
3. Wait a minimum of five (5) seconds and then re-acquire
power to stove.
4. Within 10 seconds of re-acquiring power, press the ON
button located on the Remote Control.
! NOTE: You will have only 10 seconds to perform this
last step. Failure to do so will result in these steps
needing to be followed again.
Battery Installation
To install or replace the battery:
1. Slide battery cover open on the Remote Control (Figure
2).
2. Correctly install one (1) 12 volt (A23) battery in the
battery holder.
3. Close the battery cover.
Battery must be recycled or disposed ofproperly.
Check with your Local Authority or Retailer for
recycling advice in your area.
Figure 2
On
Button
Off Button
Plastic
Strip
Battery
Cover
("II" position).
3