Advertisement
E. User-Recorded Messages
1. Pre-Time and Temperature Message
This message can be up to 30 seconds long and is played before the time and temperature is given, in place of the
"Good Morning/Afternoon/Evening" message or the "Thank You for Calling" message. To enable this message, enter
,,8 while in programming, and to disable, enter ,,7. Follow these steps to record the pre-time and temperature
announcement:
a. Enter ,1 while in programming.
b. The DVA-TNT will play "record your message now" followed by a single beep as a prompt to begin recording.
c. When finished recording, enter any touch tone to stop the recording.
d. The DVA-TNT will then playback the message just recorded. To listen to the message again, enter ,3, and the
DVA-TNT will then playback all user-recorded messages in the following order: the night message (if recorded),
the pre-time and temperature message (if recorded) and the post-time and temperature message (if recorded).
Note:
2. Post-Time and Temperature Message
This message can be up to 30 seconds long and is played after the time and temperature is given. After this mes-
sage is played, the DVA-TNT disconnects if in the ring-trip mode or starts a new message cycle if in the drum
recorder mode. To enable this message, enter ,,0 while in programming, and to disable, enter ,,9. Follow these
steps to record the post-time and temperature announcement:
a. Enter ,2 while in programming.
b. Follow steps b-d shown in section 1 above.
Note:
3. Night Message
The night message can be up to 15 seconds long and is played before the time and temperature is given. After the
time and temperature is given, the DVA-TNT disconnects if in the ring-trip mode or starts a new message cycle if in
the drum recorder mode. To enable this message, provide a contact closure across the "NIGHT MODE C.C. INPUT"
(terminals 7 and 8) on the front of the unit. Follow these steps to record the night announcement:
a. Enter ,0 while in programming.
b. Follow steps b-d shown in section 1 above.
Note:
F. Time of Day
The DVA-TNT uses a standard 12-hour clock and will announce the time as such. When the DVA-TNT is first pow-
ered up, or it has experienced a loss of power longer than the back-up battery could maintain, the time of day will need
to be set.
Note:
1. Enter programming (see Programming section A).
2. Enter two digits pertaining to the hour (01 - 12).
3. Enter the minutes (00 - 59).
4. The next digit signifies morning or afternoon, enter 0 for AM or 1 for PM.
5. Then enter "#01" to store the information.
Note:
G. Call Counter
The DVA-TNT has a call counter that can be read and reset by entering the programming mode. The call counter
capacity is 99,999 calls. To read the call counter, enter ,8 while in programming. The DVA-TNT will play "total calls"
and then speak the individual digits making up the call count number. For example, "one, one, eight, nine" would
indicate that the call count was 1,189. The call counter can be reset by entering ,9 while in programming. The DVA-
TNT will reset the call counter to zero and play "call counter has been reset." Note:
DVA-TNT
DVA-TNT
DVA-TNT
DVA-TNT
DVA-TNT
#01
DVA-TNT
DVA-TNT
Advertisement
