Vivotek IP8330 User Manual page 8

VIVOTEK
IMPORTANT!
1. The camera comes with an angled cut sunshield. If you install the camera in a ceiling-mount
orientation, you will need to change the sunshield's orientation.
To adjust the sunshield,
1-1. Loosen the sunshield seal ring using an included acrylic opener.
1-2. You do not need to remove the sunshield. Rotate the protruding ridge to the desired
direction from which sunlight can cause glare.
1-3. Hold the sunshield and the camera using one hand, and then tighten the seal ring using
the same acrylic opener.
2. Although the camera and the cable gland on the camera's end are waterproof, the cable
molding at the other end is not waterproof.
Measures should be taken to prevent water from leaking in through the cable-end molding,
such as the use of expanding foam sealant, putties, and so on. Note that the cable gland on
the camera should also be securely fastened to attain its waterproof functionality.
Cable Gland
8 - User's Manual
Seal Ring
Sunshield
Waterproof
Alignment marks
Sunshield
Camera
Not Waterproof
Cable Molding