Vinotemp VT-52SN Service Manual

Vinotemp VT-52SN Service Manual

Vt-52sn wine coolers
Hide thumbs Also See for VT-52SN:

Advertisement

TOOLS NEEDED .................................................................................................... 1
Troubleshooting .............................................................................................. 1
 
Wine cellar does not cool ................................................................................. 2
 
The cellar makes too much noise ....................................................................... 7
 
Interior light does not turn on ........................................................................... 8
 
 
 
 
The LED indicator is not operating ................................................................... 14
 
Changing the position of the handle ................................................................. 16
 
T
OOLS NEEDED
Phillips Screw
driver
Multimeter
Pliers
A)
Troubleshooting
Prior to any
equipment testing, please answer the following questions:
Is the temperature you want below the capabilities of your coole
Is the unit installed in an area with an ambient temperature over 85
Did you recently change the temperature of the unit?
Is the door open too often to maintain a proper tempe
Are there any air leaks around the door?
Are the ventilation grills blocked on either
Does the door open on its own or not close solidly?
Is there too much dust/dirt on the anti-dust net?
If
you answer YES to any of these questions, then your unit may have temperature issues
not related to the cooling equipment. Please address these issues by:
Determining the temperature capabilities of your unit to see if y
the chilled air you desire. You may need to refer to your owner's manual for this
information.
If the unit is in
may not reach the temperature you desire. Please relocate the unit to a place wher
the ambient temperature does not go over 85°F before doing any testing.
Be sure your wine cooler is not placed in direct sunlight or near any applian
generate heat (i.e. stoves, ovens, refrigerators, etc.).
Your wine cooler may require come clearance space at the
Refer to your owner's manual for clearance requirements.
Depending on the temperature change and the ambient tem
your unit, it may take 24 hours or more for your unit to get to the new temperatur
setting.
Keep the do
or closed for 12 hours and observe the unit to see if cycles on and off
several times during this period. If you see the unit cycling on and off several time
Vinotemp International ● 17621 S. Susana Road ● Rancho Dominguez, CA ● 1.800.886.3332
stalled in an area that is regularly at or above 85°F, then your unit
Service Manual for
VT-52SN Wine Coolers
rature?
side of the unit?
r?
°F?
ou unit can supply
ces that
sides and rear of the unit.
perature surrounding
 
 
 
 
 
 
 
 
 
 
e
e
s,
1

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the VT-52SN and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Vinotemp VT-52SN

  • Page 1: Table Of Contents

    12 hours and observe the unit to see if cycles on and off several times during this period. If you see the unit cycling on and off several time Vinotemp International ● 17621 S. Susana Road ● Rancho Dominguez, CA ● 1.800.886.3332...
  • Page 2: B) Wine Cellar Does Not Cool

    If the magnetic strip is not securely attached to the door or if it is not securely adhering to the cabinet after cleaning, please contact Vinotemp at 800-777-8466 to order a new magnetic strip.
  • Page 3 Reattach the control board to the control board cover and tighten each of the screws. Reconnect the wire connector to the control board (Image 4). Vinotemp International ● 17621 S. Susana Road ● Rancho Dominguez, CA ● 1.800.886.3332...
  • Page 4 Note: To purchase a replacement part for your Vinotemp wine cooler, visit www.vinotemp.com, click on "Additional Parts" then click on "Replacement Parts". If you have questions before purchasing a replacement part, call Vinotemp customer service at Vinotemp International ● 17621 S. Susana Road ● Rancho Dominguez, CA ● 1.800.886.3332...
  • Page 5 (Image 6a and 6b). Image 6a Image 6b Remove the fan blade and disconnect the fan wire connector (Image 7a and 7b). Vinotemp International ● 17621 S. Susana Road ● Rancho Dominguez, CA ● 1.800.886.3332...
  • Page 6 To install a new fan motor, attach the fan blade to the new fan motor (Images 8a and 8b). Reattach the connector to the cooler and replace the back panel of the unit (Image 9). Vinotemp International ● 17621 S. Susana Road ● Rancho Dominguez, CA ● 1.800.886.3332...
  • Page 7: C) The Cellar Makes Too Much Noise

    (Image 10). Also, check if the screws to the fan motor are loose, if so, tighten them with a screwdriver. Check if the fan blade is coming into contact with any of the surrounding metal parts. Vinotemp International ● 17621 S. Susana Road ● Rancho Dominguez, CA ● 1.800.886.3332...
  • Page 8: D) Interior Light Does Not Turn On

    Loosen the screws that attach the control board cover to the wine cooler (Image 11) and remove the cover. Then remove the control board from the control board cover. Image 11 Vinotemp International ● 17621 S. Susana Road ● Rancho Dominguez, CA ● 1.800.886.3332...
  • Page 9 Do not tighten too much as this might break the bulb. Replace the light cover then replace the racks. Vinotemp International ● 17621 S. Susana Road ● Rancho Dominguez, CA ● 1.800.886.3332...
  • Page 10 (Image 14). Be sure the correct connectors are correctly connected (Image 15). Reattach the control board cover to the cooler and replace the back panel. Image 14 Vinotemp International ● 17621 S. Susana Road ● Rancho Dominguez, CA ● 1.800.886.3332...
  • Page 11: E) The Led Indicator Displays "Er

    Remove the back panel and remove the control board cover. Remove the control board cover and loosen the screws that attach the control board to the cover. Vinotemp International ● 17621 S. Susana Road ● Rancho Dominguez, CA ● 1.800.886.3332...
  • Page 12 (Image 19). Attach the wire connector to the control board and reattach the control board to the control board cover. Replace the control board cover as well as the back panel of the cooler. Image 18 Vinotemp International ● 17621 S. Susana Road ● Rancho Dominguez, CA ● 1.800.886.3332...
  • Page 13: F) The Led Indicator Displays "Ll

    Remove the wire connectors from the control board (Image 20). Image 20 Vinotemp International ● 17621 S. Susana Road ● Rancho Dominguez, CA ● 1.800.886.3332...
  • Page 14: G) The Led Indicator Displays "Hh

    1.800.788.VINO. Remove the PVC cover from the temperature control panel (Image 22) Remove the plastic panel from the temperature controls and remove the box (Image 23). Vinotemp International ● 17621 S. Susana Road ● Rancho Dominguez, CA ● 1.800.886.3332...
  • Page 15 Replace the display board with a new one by tightening the screws on the display board to the cover. Reattach the wire connector (Image 25). Image 24 Vinotemp International ● 17621 S. Susana Road ● Rancho Dominguez, CA ● 1.800.886.3332...
  • Page 16: I) Changing The Position Of The Handle

    Remove the handle from its current position and attach it to the opposite side of the door. Tighten the four screws that are used to hold the handle securely in place. Replace the magnetic seal on the inside of the door. Vinotemp International ● 17621 S. Susana Road ● Rancho Dominguez, CA ● 1.800.886.3332...

Table of Contents

Save PDF