Log Operation; Filling; Heating Up - KOB PYROMAT DYN Operating And Maintenance Instructions Manual

4.3 Log operation

Check the storage unit temperature!
whether the storage unit temperature has dropped
so far that heating up is practical, and whether the
amount of heat to be expected can be accepted or
stored.
Maximum storage unit temperature: 90°C

4.3.1 Filling

CAUTION: Never fill shavings or woodchips di-
rectly from the grate
going up in flames suddenly!
• The slots in the grate have to be free of ash.
Only charcoal (approx. 2 cm) may remain lying
on the grate. Evenly spread out paper on this
(better than cardboard) and easily combustible
wood over the entire width of the burner
(approx. 25 cm high). Position the pieces of
wood crosswise such that a layer permeable to
air is created.
Finer material may only be filled on the layer of
chopped wood.
• Neatly lay the billet wood and logs horizontally
and compactly over the entire width of the fire-
box.
• When closing the access door, be sure that the
supporting surface for the refill access lid seal
is clean.
Note that even a small ember remaining can
also inadvertently ignite the kindling wood.
With hydraulically switched heat storage tank
Only fill the firebox partially – only reduced log op-
eration is possible!
Load with logs to a maximum of 20 kg to 40 kg per
filling, depending on the thermal acceptance.
With ECO function (option), heat accumulator
with storage control valve
• Full operation with logs.
• Only refill as much wood as energy that the
storage unit can still accommodate until the
maximum storage unit temperature of 90°C is
reached.
Check
There is a danger such

4.3.2 Heating up

Kindling
• Is the airway (1) to (3) clear through the entire
area of the grate, through fuel at the bottom and
into the combustion chamber? Is the lower part
of the wood loaded (2) permeable to air?
1
• Open the ash pan lid. Ignite, ideally doing so
over the entire width of the firebox,
• such that the fire spreads over the entire area
of the grate as quickly as possible.
Aim to keep the heating-up procedure short,
quickly producing a lot of heat and embers.
Rapid heating up of the combustion chamber
rapidly produces perfect incineration.
• Press the F1 button "PYROMAT Manual".
• Leave the ash pan lid approx. 10 cm open until
the material to be burned has started to burn
well.
• When the temperature of the exhaust gas
reaches approx. 110°C, close the ash pan lid.
10
2
3