Unlocking The Keypad; Security Keyguard - Vertu CONSTELLATION RM-389V Quick Manual

You can change the Security code with the following procedure. To reset the
code, you will need to bring your Vertu phone in to the Vertu Customer
Service centre, Vertu store or authorised Vertu dealer. Extreme care should
be taken so as not to forget your Security code.
To change Security code:
1. Open the fold and press the [End] key until the Home screen appears.
2. Select Menu » Settings » Security » Access codes » Change
security code.
3. Enter the current Security code and select OK.
4. Enter a new five to ten digit Security code and select OK.
5. Enter the new code again (for reconfirmation), and then select OK.
A confirmation message appears, and then, the new Security code is enabled.
>
Locking the keypad
You can lock the keypad on your Vertu phone to prevent accidentally
dialling any numbers.
1. Open the fold and press the [End] key until the Home screen appears.
2. Press the centre [SELECT] key, then press the [ * ] key within two
seconds.
A confirmation message appears, and the keypad will be temporarily locked.
>
will appear at the top of the inner display with Unlock shown at the
bottom.
When you receive an incoming call, the keypad lock is automatically
suspended. When the call is ended, the keypad returns to the locked state.
Tip: You can also lock the keypad using the following procedure:
Open your Vertu phone and give a short press on the [Power] key
>
to display the Profiles list. Press the [Navigation] key (Up) and
select Lock keypad from the list
Tip: You can follow the steps below to enable a setting whereby the
keypad is automatically locked if there is no key operation on the
phone for a specified period when your Vertu phone is open or closed:
1. Open the fold and press the [End] key until the Home screen appears.
2. Select Menu » Settings » Phone » Automatic keyguard » On.
3. Enter the duration of inactivity (ranging from 5 seconds to 60 minutes)
before automatically locking the keypad, and select OK.

Unlocking the keypad

You can unclock the keypad just by closing your Vertu phone and then re-
opening it. Or You can also cancel the keypad lock by pressing Unlock
(centre [SELECT] key), and then the [ * ] key within two seconds while the
fold is open. Note that you can still control Media player using buttons on
the outer display, even if you close your Vertu phone while you are playing
music or video on the player with the fold open.

Security keyguard

By enabling the Security keyguard feature, you can make a Security code
entry necessary, each time the keypad is locked or you switch on your
Vertu phone. Since your Vertu phone cannot be used without a Security
code entery, this feature, if set, could be an effective prevention against
unauthorised use.
To enable the Security keyguard protection:
1. Open the fold and press the [End] key until the Home screen appears.
2. Select Menu » Settings » Phone » Security keyguard » On.
3. Enter the Security code and select OK.
Typical Security keyguard use case example:
1. Open the fold and press the [End] key until the Home screen appears.
2. Press the centre [SELECT] key, then press the [ * ] key within two
seconds, to activate the keypad lock.
3. Close the phone and re-open it in a bid to unclock the keypad.
4. Since the Security keyguard feature has been set, the Security code input
screen appears; Enter the Security code to actually unlock the keypad.
Using your Vertu phone 41