Restoring Defaults - Velodyne DIGITAL DRIVE SERIES User Manual

By pressing the SelecT button, you tell the system to save your settings and return to the introduction screen.
Selecting NO returns without saving (i.e. whatever previous settings were in effect will be used), and CANCEL
keeps you in setup mode.
When the unit saves settings, you will see the video flicker and you may hear a slight tick in your main speakers.
This is normal behavior.
NOTE: The digital drive subwoofer stores all of its settings in internal "Flash" memory. This memory persists
even if the woofer is turned off, loses power, or undergoes a programming update, so you need not worry about
losing your customized settings.

RESTORING dEFAULTS

There is a feature in digital drive that allows you to restore the factory defaults. On the main Screen, simply
press the 8, 9, and 0 buttons in sequence. If you are successful, the unit will flicker the video and then restore
the main screen. The system responds with a defaults restored message, as shown below:
36 - Digital Drive Series User's Manual
www.velodyne.com