Restoring Defaults - Velodyne Digital Drive User Manual

By pressing the SELECT button, you tell the system to save your settings and return to the
introduction screen. Selecting NO returns without saving (i.e. whatever previous settings were
in effect will be used), and CANCEL keeps you in setup mode.
When the unit saves settings, you will see the video flicker and you may hear a slight tick in your
main speakers. This is normal behavior.
NOTE: The Digital Drive subwoofer stores all of its settings in internal "Flash" memory. This
memory persists even if the woofer is turned off, loses power, or undergoes a programming
update, so you need not worry about losing your customized settings.
R e s t o r i n g D e fa u l t s
There is a feature in Digital Drive that allows you to restore the factory defaults. On the Main
Screen, simply press the 8, 9, and 0 buttons in sequence. If you are successful, the unit will
flicker the video and then restore the main screen. The system responds with a defaults
restored message, as shown below:
.
w w w . v e l o d y n e . c o m
37
Digital Drive User's Manual