Installing The Model 8340 Scsi Card - Fostex VF08 Owner's Manual

Installing the Model 8340 SCSI card

Follow the procedure below to install the Model 8340 SCSI card in the VF08.
<Notes>
• Before installing the Model 8340 SCSI card in the VF08,
turn off the VF08 power and disconnect the power
cord.
• The SCSI card is comprised of precision parts.
Be careful not to give a strong shock or excess of power
when installing the card.
• Follow the procedure below to install the card in the
VF08. Note that Fostex is not responsible for any
damage of products caused by the incorrect
installation.
Remove the cover panel located on the right side of the
1
VF08.
The two retaining screws will be used later for fixing the
SCSI card in step 3.
Unfasten the two screws.
Remove the panel.
The blank panel is not used.
Insert the SCSI card as shown in the figure below until
2
the board meshes with the internal connector.
With the component side up, insert the SCSI card gen-
tly. Do not push the board with excessive force.
SCSI card (Model 8340)
After inserting the board, fix back the cover panel re-
3
moved in step 1.
Place the panel to the correct position, and fasten it us-
ing the screws which are unfastened in step 1.
Fasten the screws not to loosen.
115
Specifications
component side up
cover panel