Table of Contents
Advertisement
Remote control FAQ
This section covers som of the most frequently asked
questions regarding remote control of the DBMAX.
Q: What parameters can be set using serial remote control
of the DBMax?
A: Preset change and Bypass using an RS485/422/232
controller.
Q: What serial protocol is used?
A: The serial protocol is 9600, N, 8, 1.
This means 9.6 kbaud, no parity, 8 bit, 1 stop.
Q: What is the command structure for the remote protocol?
A: #AA,CMD,VALUE<CR>
AA is Unit Address number as set on the Utility page.
CMD is command: PRE for preset change, BYP for
Bypass.
VALUE is (RAM) preset number required, 0 for not
bypassed, 1 for bypassed; <CR> is carriage return, the
same as Enter or hex 0D.
Examples:
#05,PRE,10<CR> =Recall RAM preset no. 10 on
DBMaxaddress 5.
#03,BYP,1<CR>
=Bypass DBMaxaddress 3.
All commands and numbers are shown as ASCII. Presets
should not include a "0" in front of low numbers.
Q: What ASCII characters should be sent for Recall of
RAM preset no. 10 on DBMax address 5?
A: #05,PRE,10<CR> means these values (hex) actually
transmitted: 23 30 35 2C 50 52 45 2C 31 30 0D
58
Hide quick links:
Advertisement
Table of Contents
