Calibration Tone - TC Electronic DBMAX-V 2.90 User Manual

V 2.90 digital broadcast maximizer broadcast series

Hide thumbs

Table Of Contents

Table of Contents

TOOLS

DIO & Calibration Tone

This display has various indicators describing the

received digital signal.

Pre-emphasis

This parameter indicates whether the incoming signal is

pre-emphasized or not.

Source device (Category code)

The device status of the received signal is shown in this indicator.

Audio data

The number of received audio bits is indicated here.

Status of the copybits.

Note: The above information can only be displayed if the

information is present in the digital signal.

Out

In this display you set up how the DBMAX should

output your material.

COPY ENABLE

Set the copyrights of your material:

- No copies

- 1 copy only

- Infinite number of copies.

Note: The copy protection is only valid with S/PDIF signals.

Status Bit Out

AES/EBU

When AES/EBU is selected the DBMAX will transmit its own

professional set of status bits, meaning that any incoming ID will

be lost. However, in order to take full advantage of the

DBMAX's 24 bit resolution you should select AES/EBU to make

sure that the receiving device after the DBMAX will accept all

24 bits.

S/PDIF

When S/PDIF is selected, the DBMAX will transmit its own

consumer status bits out, meaning that any incoming ID will be

lost. The DBMAX's S/PDIF Output carries up to 24 bits.

Only the S/PDIF signal contains copy protection information.

From Input

When this setting is selected the DBMAX will transmit the same

information as it received. However, you still have the possibility

to change the copy status.