Appendix; Troubleshooting - TC Electronic DBMAX-V 2.90 User Manual

APPENDIX -

Troubleshooting

You press the POWER switch but there is no light
- The POWER switch on the rear panel is switched off.
The Input PPM meters don't peak out
- You are using analog Inputs, but the Input selector in the I/O menu is set to digital in.
- The analog Input level is set too low.
No sound through the DBMAX
- You are using analog Inputs, but the Input selector in the I/O menu is set to digital in.
You cannot turn the power off
- Hold the POWER switch pressed for at least 3 seconds.
You hear a lot of noise on the DBMAX Output
- 8 bit dither is on, go to the out section and select a suitable dither.
48