Show Logging Hosts - Fortinet MR1 User Manual

Syntax
show logging traplogs
Default Setting
None
Command Mode
Privileged Exec
Display Message
Number of Traps since last reset: The number of traps that have occurred since the last reset of this
device.
Trap Log Capacity: The maximum number of traps that could be stored in the switch.
Log: The sequence number of this trap.
System Up Time: The relative time since the last reboot of the switch at which this trap occurred.
Trap: The relevant information of this trap.
Note: Trap log information is not retained across a switch reset.

5.5.3.1 show logging hosts

This command displays all configured logging hosts.
Syntax
show logging hosts
Default Setting
None
Command Mode
Privileged Exec
Display Message
Index (used for deleting)
IP Address IP Address of the configured server.
Severity The minimum severity to log to the specified address.
Port Server Port Number.This is the port on the local host from which syslog messages are sent.
Status The state of logging to configured syslog hosts. If the status is disable, no logging occurs.
183