Warming Throw Setup; Control Features - Sunbeam Sleep warm. Sleep well. User Manual

Warming Throw Setup

When setting up your warming throw, be sure to follow the steps below in order.
1 Locate the warming throw's information label near the module.
2 Connect the cord into the module at the bottom of the warming throw until
the plastic hinges click into place.
CAUTION: Cord must be COMPLETELY CONNECTED. A risk of fire could result
from a loose connection.
3
Flag Tag
3 Plug the [warming throw] power cord into a 110-120 volt wall outlet.
IMPORTANT
CAUTION: Do not plug main power cord into the wall outlet until you have completely set up
your heated product per the instructions.
• Disconnect power cord from wall before detaching control from heated product.
• Always make sure cords and controls are NOT trapped or pinched between bed slats, mattress, springs,
against wall, foot board or bed frame, or between furniture, walls or chairs.
• Do not wrap control in throw when in use.
• Do not use with generator power.
CAUTION: Do not attempt to force the plug. This appliance has a polarized plug (one blade is wider than the
other). To reduce the risk of electrical shock, this plug is intended to fit only one way into an outlet.
If the plug does not fit in the outlet, reverse the plug. If it still does not fit, contact a qualified electrician.
Do not attempt to defeat this safety feature.

Control Features

PrimeStyle
™
M85P
Non Auto-Off
PrimeStyle
AO
™
M85AP
Auto-Off
EliteStyle
™
N85AP
Auto-Off
Control
Power
Cord
1
Label
2
Module
Throw Cord
Throw Cord
Connector
Using Your Warming Throw Control:
1 To turn on the throw press the button in the middle of the control.
CAUTION: ALWAYS turn the warming throw "OFF" and disconnect the
power cord from the outlet when not in use.
2 To turn the warming throw OFF press the button through the different
Features:
• 3 TEMPERATURE SETTINGS – select your personal comfort level
• SILENT OPERATION – no clicking when adjusting the temperature
• SOLID STATE – for accurate and consistent heat control
• EASY OPERATION – electronic control for easy operation
• EASY GRIP – ergonomic control for easy operation
• AUTO-OFF (Selected models only) – 3 hour Auto-Off operation
For questions or support, please visit: www.sunbeam.com
3
Flag Tag
Power
Cord
2
Throw Cord
Connector
The indicator light will glow, depending on which setting the warming throw
is set, and the warming throw will begin to warm.
settings until the temperature setting lights are not glowing.
2
If there is a flashing light on
your control, see page 8.
Control
1
Label
Module
Throw Cord
(see page 1)
5