Care And Cleaning - Sunbeam Sleep warm. Sleep well. User Manual

Care and Cleaning

OF YOUR HEATED PRODUCT
We recommend washing before initial use.
Before Washing or Storing Your Heated Product:
1 Disconnect power cord from wall BEFORE detaching control cord from the heated product.
2 Ensure that no cords are still connected and none of the wires have worn through the fabric.
3 Carefully follow all washing instructions or your heated product may shrink and possibly cause a fire hazard.
• DO NOT submerge control in water.
• DO NOT dry clean your heated product. Dry cleaning solvents may damage the wires.
• DO NOT use bleach or cleaning fluids.
• DO NOT use a wringer.
• DO NOT iron your heated product.
• DO NOT use mothballs or sprays of any kind.
• DO NOT reconnect the heated product or use it until it is COMPLETELY dry.
• DO NOT wash or put into water the power cord or any of the product's cords.
• DO NOT use analgesic cream in combination with your heated product.
Taking care of your heated product is easy and safe as long as you follow a few simple steps.
Machine Washing
1 Presoak the blanket/mattress pad/throw for 15 minutes in mild soap and cold water.
2 Wash in mild soap and cold water on the "delicate" or "gentle" cycle in the washer for two minutes.
Remember, do not use bleach.
3 Rinse in fresh, cold water.
4 Spin dry in the washing machine. Then gently stretch to its original size.
Machine Drying
Caution: Do not use commercial dryers or the dryers at your local laundromat. They get too hot and would
damage the wiring of the heated product.
1 Preheat the dryer on the "low" temperature setting for 2 minutes.
2 Place blanket/mattress pad/throw into the dryer and tumble dry for 10 minutes at a low temperature.
3 Remove the blanket/mattress pad/throw while it is still damp and gently stretch it to its original size.
4 Drape the heated product over a clothesline or a shower rod. DO NOT use clothespins.
5 Heated product must be COMPLETELY dry before reconnecting the power plug or control plug.
Hand Drying
1 Gently stretch the blanket/mattress pad/throw back to its original size.
2 Drape the heated product over a clothesline or hang over a shower rod. DO NOT use clothespins.
3 Heated product must be COMPLETELY dry before reconnecting the power plug or control plug.
6
For questions or support, please visit: www.sunbeam.com