Advertisement
Slicing Hints.
Always place food to be sliced on a wooden or
plastic cutting board. Do not slice food on china;
metal or bench tops, as scratching may occur.
Guide blades through food. A sawing action is
not necessary. Do not force blades through food.
To maintain the sharpness of blades, do not cut
through bones, fruit pips or stones or any other
hard substances.
For best results when carving meat and poultry
allow cooked meat to stand for 10-15 minutes
before slicing. this allows the juices to set and
makes carving easier and neater.
Care and Cleaning.
Warning: Ensure the unit is switched off and
the plug removed from the power outlet before
removing the blades and/or cleaning.
Unlock the blades by sliding apart. Always hold
blades by the shaft end, behind the safety
guard, when handling and cleaning. Wash the
blades in hot soapy water with a soft cloth or
sponge. Rinse thoroughly and dry completely.
Sunbeam is a registered trademark. Carveasy is a
trademark of the Sunbeam Corporation. Made in China.
Due to minor changes in design or otherwise, the product
may differ from the one shown in this leaflet. Approved by
the appropriate Electrical Regulatory Authorities. Backed
by Sunbeam's 12 Month Replacement Guarantee and
National Service Network.
Before carving meat or chicken, remove skewers.
If desired, string may be left around the meat
whilst carving. The use of a carving fork to
steady the meat assists in carving straight, even
slices. Do not attempt to sharpen blades.
We recommend when slicing foods like bread, a
light smear of cooking oil, margarine or similar,
on the inside of the blades will reduce the
friction.
Do not use abrasive scouring pads or powders
on blades. After cleaning, always store blades in
plastic sleeves. To clean motor housing wipe
with a soft damp cloth.
Before storing your knife, a light smear of
cooking oil or similar on the inside of the blade
is suggested.
© Copyright. SUNBEAM CORPORATION LIMITED 2001.
(INCORPORATED IN N.S.W.) A.C.N. 000 006 771
For more information or advice on any Sunbeam products,
contact the Sunbeam Consumer Service Line on 1800 025 059
in Australia. In New Zealand - contact the Sunbeam Office in
Auckland on 09 912 0747.
Advertisement
