Drive Installation and Enclosure Setup
7. Connect the supplied eSATA data cable between the enclosure
and the SATA host controller in your computer; verify the con-
nectors are plugged in securely (Figure 7).
8. Connect the supplied power cable between the Fusion 500P
and a grounded wall outlet or power strip; verify the cable is
plugged in securely.
9. Push the switch on the back of the enclosure to the ON position,
and then power on your computer.
10. Format the drives installed in the Fusion 500P according to your
needs; refer to your operating system's software guide or help sec-
tion for more information.
4
eSATA data cable
Figure 7