FortiGate-100 Installation and Configuration Guide Version 2.50 MR2
NAT/Route mode installation
Preparing to configure NAT/Route mode
FortiGate-100 Installation and Configuration Guide
This chapter describes how to install the FortiGate unit in NAT/Route mode. To install
the FortiGate unit in Transparent mode, see
page
57.
This chapter describes:
•
Preparing to configure NAT/Route mode
•
Using the setup wizard
•
Using the command line interface
•
Connecting the FortiGate unit to your networks
•
Configuring your networks
•
Completing the configuration
•
Configuration example: Multiple connections to the Internet
Use
Table 10
to gather the information that you need to customize NAT/Route mode
settings.
Table 10: NAT/Route mode settings
Administrator password:
Internal
interface
External
interface
Internal servers
If you provide access from the Internet to a web server, mail server, IMAP
server, or FTP server installed on an internal network, add the IP
addresses of the servers here.
"Transparent mode installation" on
IP:
Netmask:
IP:
Netmask:
Default Gateway:
Primary DNS Server:
Secondary DNS Server:
Web Server:
SMTP Server:
POP3 Server:
IMAP Server:
FTP Server:
_____._____._____._____
_____._____._____._____
_____._____._____._____
_____._____._____._____
_____._____._____._____
_____._____._____._____
_____._____._____._____
_____._____._____._____
_____._____._____._____
_____._____._____._____
_____._____._____._____
_____._____._____._____
43