Table of Contents
Advertisement
Floor Mounting
Rear position
Front position
Wall Mounting
Power Supply Cord
WARNING
Electrical Shock Hazard
Disconnect power before servicing.
Use a new 40 amp power supply cord.
Plug into a grounded outlet.
Failure to follow these instructions can result in death,
fire, or electrical shock.
1. Disconnect power
2. Remove the terminal block cover screws located on the back
of the range. Pull cover down and toward you to remove
cover.
A. Hold-down screws
B. Terminal block cover
5. Using the Phillips screwdriver, mount anti-tip bracket to the
6. Move range close enough to opening to allow for final gas
7. Move range into its final location, making sure rear leveling
Diagonal (2 options)
8. Move range forward onto shipping base, cardboard or
Electrical Connection
Direct Wire
3. Add strain relief.
A
B
wall or floor with the two #12 x 1 " screws provided.
and electrical connections. Remove shipping base,
cardboard or hardboard from under range.
leg slides into anti-tip bracket.
hardboard to continue installing the range using the following
installation instructions.
WARNING
Electrical Shock Hazard
Disconnect power before servicing.
Use 8 gauge copper or 6 gauge aluminum wire.
Electrically ground range.
Failure to follow these instructions can result in death,
fire, or electrical shock.
Style 1: Power supply cord strain relief
Assemble a UL listed strain relief in the opening.
A
A. UL listed strain relief - large opening
B. Small opening
Feed the power supply cord through the strain relief on
the cord/conduit plate on bottom of range. Allow enough
slack to easily attach the wiring to the terminal block.
B
7
Advertisement
Table of Contents
