Excel 500-Xcl5010; Excel 500-Xcl5010 Communication Module; Installation Through A Control Panel Door (Not Xcl5010) - Honeywell Excel 500 Installation Instructions Manual

EXCEL 500/600 INSTALLATION INSTRUCTIONS

Excel 500-XCL5010

1. Attach the DIN rail mounting clips to the housing.
2. Mount the controller on the DIN rail.
1
2
3
Fig. 16. Mounting Excel 500-XCL5010 on DIN rail

Excel 500-XCL5010 Communication Module

CAUTION
Always plug in the communication module before
connecting the power supply.
Always disconnect the power supply before
unplugging the communication module.
Fig. 17. Inserting the communication module
EN1R-1047GE51 R0902
Plug in the communication module until it snaps into the con­
troller housing
NOTE: If the communication module has been replaced or
Installation through a Control Panel Door
(not XCL5010)
IMPORTANT
1
1, Prepare the door in accordance with the following.
2. Insert the housing.
3. Insert the retaining clamp.
10
pulled out and plugged in again, push the reset
button after power on.
Observer the minimum spacing of 1.5 in. (35 mm)
when installing more than one housing. Do not ex-
ceed the maximum spacing; otherwise, the tailor-
made internal bus cables will be too short.
dimensions.
Fig. 18. Panel door mounting dimensions
Fig. 19. Inserting the housing in the panel door