Single Unit - Shure P4T User Manual

Hide thumbs Also See for P4T:

RACK MOUNTING THE P4T

The P4T features a

-rack chassis specially designed for sturdiness. This eliminates the sagging and bending found in most

designs. The brackets and straddle bars ensure that the units will be installed securely.

WARNING: Do not torque the screws too tightly, or the chassis may be damaged.

SINGLE UNIT

MOUNTING IN AN EQUIPMENT RACK

NOTE: Be sure to use both straddle bars when installing dual units.

FRONT MOUNTING THE ANTENNA

The P4T transmitter comes equipped so the antenna can be front-mounted. Front-mounting prevents antenna cables from becoming en-

tangled and greatly minimizes RF interference from other cables. When a unit is located in a rack, antennas should be either front- or

remote-mounted.

1. Insert the bulkhead adapter

through either hole of the mount-

ing bracket and secure it from the

back using the supplied hardware.

2. Connect the transmitter antenna

output to the bulkhead adapter

with the supplied RF cable.

NOTE: The PA715 antenna, which comes supplied with the P4T, cannot be remote mounted. Use a PA705 antenna for remote mounting.

ENGLISH

DUAL-MOUNTED UNITS

3. Install the antenna on the

bulkhead adapter.

-rack

Table of Contents