Advertisement
back panel of the cooker could reach a temperature of
50°C above room temperature. For proper installation of
the cooktop, the following guidlines must be followed:
a) If the cabinet(s) located next to the cooktop are higher
than the cooktop itself, the cabinet(s) must be installed
at least 110 mm from the edge cooktop;
b) Hoods must be installed in accordance with the
instructions contained in the installation manual for the
hoods themselves, and no less than 650 mm from the
cooktop;
c) The cabinets installed next to the hood must be located
at a height of at least 420 mm from the top, (as shown
in Fig. C).
Min.
d) Should the cooktop be installed directly under a
cupboard, the latter should be at least 700 mm
(millimetres) from the top, as shown in Fig. C.
e) The dimensions of the cutout for the appliance must
be those indicated in the figure D. Clamps are provided
to fasten the cooktop to counters measuring from 20
to 40 mm in thickness. To fasten the cooktop securely,
it is recommended that all the clamps be used.
55
mm
Fastening Clamps - Assembly Diagram
Clamp Position for
HOOD
600
mm.
Fig. C
555
mm
Clamp Position for
H=20mm top
Clamp Position for
H=40mm top
N.B: Use the clamps contained in the "accessory kit."
f) In the event the cooktop is not installed above a built-in
oven, a wood panel must be inserted as insulation. This
panel must be placed at least 20 mm from the bottom of
the cooktop itself.
Important: When installing the cooktop above a built-in oven,
the oven should be placed on two wooden strips; in the case
of a joining cabinet surface, remember to leave a space of at
least 45 x 560 mm at the back.
When installing the cooktop above a built-in oven without
forced ventilation, ensure that there are air inlets and outlets
for ventilating the interior of the cabinet adequately.
Gas Connection for Cooktop
The cooktop should be connected to the gas supply by an
authorized installer. During installation of this product it is
essential to fit an approved gas tap to isolate the supply from
the appliance for the convenience of any subsequent removal
or servicing. Connection of the appliance to the gas mains
or liquid gas tanks must be carried out according to the safety
standards currently in force, and only after it is ascertained
that it is suitable for the type of gas to be used. If not, follow
the instructions indicated in the section entitled, "Adapting
the Cooktop for Different Types of Gas". If the cooktop is to
be connected to tanks containing liquid gas, use pressure
regulators that comply with current safety standards.
5
H=30mm top
Front
Back
Advertisement
