Table of Contents
Advertisement
A
X
4
5
F
-
4
D
S
e
r
i
e
A
X
4
5
F
-
4
D
S
e
r
i
e
Windows XP Installation Guide
************************************************************
Installing Driver during New Windows XP Installation
************************************************************
1. Start the installation:
a. Floppy Install: Boot the computer with the Windows XP installation diskettes.
b. Floppyless Install: Boot from floppy and type "WINNT". After files have been copied, the system will reboot. On the reboot, press
<F6> after the message "Setup is inspecting your computer's hardware configuration..." appears.
c. CD-ROM Install: Boot from the CD-ROM. Press <F6> after the message "Press F6 if you need to install third party SCSI or RAID
driver" appears.
2. When the "Windows XP Setup" window is generated, press "S" to Specify an Additional Device(s)
3. Insert the Promise SATA150 driver diskette into drive A: and press "Enter" key.
4. Use "◆" or "□" to choose "Win XP Promise SATA TX2plus (tm) IDE Controller" from the list that appears on screen, and then press
the "Enter" key.
5. Press "S" to use the driver on the floppy disk, and then press "enter" to continue with installation. If you press "enter" to use "Windows
default driver", you will encounter the following error message in the next phase of the installation: "Setup did not find any hard disk
drives installed in your computer"
NOTE: Restart installation and then use option "S" to load driver from floppy disk.
6. The Windows XP Setup screen will appear again saying, "Setup will load support for the following mass storage devices:" The list will
s
s
126
O
n
l
i
n
e
M
a
n
u
a
l
O
n
l
i
n
e
M
a
n
u
a
l
Hide quick links:
Advertisement
Table of Contents
