Table of Contents
Advertisement
A
X
4
5
F
-
4
D
S
e
r
i
e
A
X
4
5
F
-
4
D
S
e
r
i
e
Windows 2000 Installation Guide
**************************************************************
Installing Driver during New Windows 2000 Installation
**************************************************************
1. Start the installation:
a. Floppy Install: Boot the computer with the Windows 2000 installation diskettes.
b. Floppyless Install: Boot from floppy and type "WINNT". After files have been copied, the system will reboot. On the reboot, press
<F6> after the message "Setup is inspecting your computer's hardware configuration..." appears.
c. CD-ROM Install: Boot from the CD-ROM. Press <F6> after the message "Press F6 if you need to install third party SCSI or RAID
driver" appears.
2. When the "Windows 2000 Setup" window is generated, press "S" to Specify an Additional Device(s)
3. Insert the Promise SATA150 driver diskette into drive A: and press "Enter" key.
4. Use "◆" or "□" to choose "Win2000 Promise SATA TX2plus (tm) IDE Controller" from the list that appears on screen, and then press
the "Enter" key.
5. The Windows 2000 Setup screen will appear again saying "Setup will load support for the following mass storage devices:" The list
will include "Win2000 Promise SATA TX2plus (tm) IDE Controller".
NOTE: If you need to specify any additional devices to be installed, do so at this time. Once all devices are specified, continue to the
next step.
s
s
123
O
n
l
i
n
e
M
a
n
u
a
l
O
n
l
i
n
e
M
a
n
u
a
l
Hide quick links:
Advertisement
Table of Contents
