Table of Contents
Advertisement
Connecting Onkyo
Step 1:
Make sure that each Onkyo component is connected
with an analog audio cable (connection
16).
examples)
(➔
Step 2:
Make the
connection (see illustration below).
Step 3:
If you're using an RI Dock, or cassette tape deck,
change the Input Display
(➔
With
(Remote Interactive), you can use the following
special functions:
■
System On/Auto Power On
When you start playback on a component connected via
while the AV receiver is on Standby, the AV
receiver will automatically turn on and select that com-
ponent as the input source.
■
Direct Change
When playback is started on a component connected via
, the AV receiver automatically selects that compo-
nent as the input source.
■
Remote Control
You can use the AV receiver's remote controller to con-
trol your other
-capable Onkyo components, point-
ing the remote controller at the AV receiver's remote
control sensor instead of the component. You must enter
the appropriate remote control code first
Connecting Antenna
This section explains how to connect the supplied indoor FM antenna and AM loop antenna.
The AV receiver won't pick up any radio signals without any antenna connected, so you must connect the antenna to use
the tuner.
North American and
Taiwan models
Insert the plug fully
into the jack.
Thumbtacks, etc.
Indoor FM antenna (supplied)
Note
• Once your AV receiver is ready for use, you'll need to tune into a radio station and position the antenna to achieve the best possible
reception.
• Keep the AM loop antenna as far away as possible from your AV receiver, TV, speaker cables, and power cords.
Tip
• If you cannot achieve good reception with the supplied indoor FM antenna, try a commercially available outdoor FM antenna instead.
• If you cannot achieve good reception with the supplied indoor AM loop antenna, try using it with a commercially available outdoor AM
antenna.
Components
in the hookup
22).
(➔
57).
European, Australian and
Asian models
Insert the plug fully
into the jack.
Note
• Use only
cables for
connections.
with Onkyo players (DVD, CD, etc.).
• Some components have two
one to the AV receiver. The other jack is for connecting addi-
tional
-capable components.
• Connect only Onkyo components to
manufacturer's components may cause a malfunction.
• Some components may not support all
the manuals supplied with your other Onkyo components.
• While Zone 2 is on, the System On/Auto Power On and Direct
Change
functions do not work.
REMOTE
CONTROL
e.g., CD player
e.g., DVD player
Caution
• Be careful that you don't injure yourself when
using thumbtacks.
Push.
Insert wire.
Assembling the AM loop antenna
AM loop antenna (supplied)
cables are supplied
jacks. You can connect either
jacks. Connecting other
functions. Refer to
IN
L
R
TV/CD
IN
L
R
BD/DVD
R
L
ANALOG
AUDIO OUT
R
L
ANALOG
AUDIO OUT
Release.
En
17
Hide quick links:
Advertisement
Table of Contents
