Table of Contents
Advertisement
Factory Default and Reset States
The table on the next page shows the settings of the instrument after a
reset.
• You can reset the instrument either by pressing
• If a module is accidentally removed or installed while the
3488 Mode Defaults
Item
Interface
GPIB/488
RS-232
System Mode
SCPI Mode
3488A Mode
System-Related
Display State
Stored State
Error Queue
Module-Related
Switching Channels
Digital I/O Ports
Card Pair
Scan-Related
Scanning
Scan List
Channel Delay
(seconds)
Trigger Out Pulse
a. Current setting includes the selection of the GPIB interface and its address setting.
b. RS-232 interface CANNOT be used in 3488A mode.
Shift + Card Reset on the front-panel, or with a RESET command
over the remote interface.
instrument power is on, the instrument will preform a reset.
Factory Default
GPIB (Address 9)
b
SCPI Mode
On
Empty
Empty
Open
Input
None
None
Empty
0
Disabled
Chapter 3 System Overview
Factory Default and Reset States
Reset
Keep current setting
Keep current setting
Keep current setting
Keep current setting
On
Keep current setting
Cleared
Open
Input
None
Stop scan in progress
Empty
0
Disabled
4
3
a
71
Advertisement
Table of Contents
