Prepare The Command Module - HP E1418A Service Manual

Note
Terminal Module
Connections
Prepare the
Command Module
Chapter 2
With no jumpers installed, the module will be in the Program Selectable
output mode.
If you are using a terminal module dedicated to testing the HP E1418A,
you can remove all the jumpers or put the jumpers in the storage
position.
If you are using the end-user's terminal module, record the positions of
the jumpers. Set the P/J jumpers to the programmable position. Before
returning the module to use, restore the P/J jumpers to their original
position.
Figure 2-1. P/J and V/I Jumpers
The Verification Tests require four-wire connections at each channel. The
Adjustment procedures can be performed using a single connections at the
CAL terminals. Additional connection information is given in the
procedures in Chapters 4 and 5 of this manual.
All verification and adjustment procedures in this manual use SCPI
(Standard Commands for Programmable Instruments). Prepare the
command module by downloading the SCPI driver named " E1418".
Downloading instructions are given in the Installing Device Drivers
installation note.
Installation 17