Table of Contents
Advertisement
NetVanta 2000 Series Hardware Installation Guide
6. Check the
S
PECIFY AN
7. Continue with one of the following options:
Set the IP Address Yourself
•
Enter the
IP A
•
Enter the
S
UBNET
8. Click
to close the
OK
9. Click
on the
OK
computer.
10. Click
to reboot your computer.
Y
ES
If your network uses DHCP for dynamic IP addressing, remember to return the TCP/IP
properties of your computer back to dynamic IP addressing after completing your
installation.
®
POSIX
-Compliant UNIX
1. Log in as
, or change to
root
2. Run the
ifconfig
will show the Ethernet interface name as well. For example:
#ifconfig -a
lo0: flags=863<UP,LOOPBACK,RUNNING,MULTICAST> mtu 8232 inet 127.0.0.1 netmask ff000000
hme0: flags=863<UP,BROADCAST,NOTRAILERS,RUNNING,MULTICAST> mtu 1500
inet 192.103.55.186 netmask ffffff00 broadcast 192.103.255.255
ether 8:0:20:a8:38:c6
3. Change the IP address of the Ethernet interface to 10.10.10.50 with subnet mask 255.255.255.0 by
using the ifconfig command. For example:
# ifconfig eth0 10.10.10.50 netmask 255.255.255.0
4. Run the ifconfig command -a option again to make sure the interface address change is effective.
61202361L2-34D
radio button.
IP A
DDRESS
as 10.10.10.50
DDRESS
as 255.255.255.0.
M
ASK
window.
P
ROPERTIES
configuration window, which will ask you to reboot the browser
N
ETWORK
®
®
/LINUX
.
superuser
command
option to list the configured network interfaces in the system. This
-a
Copyright © 2006 ADTRAN, Inc.
Installing Management Components
OR
Use DHCP to Assign an IP Address
•
Enable the
O
A
UTOMATICALLY
IP A
BTAIN AN
DDRESS
checkbox.
33
Advertisement
Table of Contents
