Table of Contents
Advertisement
NetVanta 2000 Series Hardware Installation Guide
NetVanta 2300 and NetVanta 2400
Instructions for Wall Mounting NetVanta 2300 or NetVanta 2400
Step
1
Orient the brackets (mounting ears), one on each side, such that the portion of the bracket with
the mounting holes is flush with the bottom of the chassis (see Figure 10 on page 28). (If the
brackets are already attached in a rackmount position, you will have to detach them and rotate
them 90 degrees to orient them properly, as shown in the figure.)
2
Decide on a location for the NetVanta 2000 Series. Mount the unit at or below eye-level so that
the LEDs are viewable.
Important! Mount the chassis with LEDs facing to the side (not up or down) as shown in
Figure 10).
3
Prepare the mounting surface by attaching a board (typically plywood, 3/ 4- to 1-inch thick) to a
wall stud.
Important! Mounting to a stud ensures stability. Using sheetrock anchors may not provide
sufficient long-term stability.
4
Have someone else hold the unit in position as you install two 3/ 32- to 1/ 8-inch (1 1/ 2 inches
or greater in length) wood screws through the each of the unit's brackets and into the mounted
board. See Figure 10 on page 28.
5
Proceed to the steps given in Supplying Power to the Unit on page 29.
To avoid damaging unit, use only the screws included in shipment when attaching
mounting ears to the chassis.
61202361L2-34D
Action
Copyright © 2006 ADTRAN, Inc.
Unit Installation
27
Advertisement
Table of Contents
