Table of Contents
Advertisement
Unit Installation
Wall Mounting NetVanta 2000 Series Internet Security Appliances
NetVanta 2050, NetVanta 2054, and NetVanta 2100
Instructions for Wall Mounting NetVanta 2050, NetVanta 2054, or NetVanta 2100
Step
1
Decide on a location for the NetVanta. Mount the unit at or below eye-level so that the LEDs are
viewable.
2
Prepare the mounting surface by attaching a board (typically plywood, 3/ 4- to 1-inches thick) to
a wall stud.
Important! Mounting to a stud ensures stability. Using sheetrock anchors may not provide
sufficient long-term stability.
3
Install two #8 (1 1/ 2 inches or greater in length) wood screws into the mounted board following
these guidelines and referring to Figure 9:
•
Screws should be spaced horizontally, approximately 5 inches apart. Find exact positioning
by using the location of the two keyed insets on the bottom of the NetVanta as a guide. You
can also use the Mounting Template located on your ADTRAN OS System Documentation
CD.
•
Screws should be horizontally level with each other.
•
Leave approximately 1/4 inch of the screws protruding from the board to allow the heads of
the screws to slide into place in the unit's keyed insets.
4
Slide the keyed insets on the bottom of the NetVanta chassis securely onto the screws.
5
Proceed to the steps given in Supplying Power to the Unit on page 29.
Figure 9. Wall Mounting the NetVanta 2050, NetVanta 2054, or NetVanta 2100
26
NetVanta 2000 Series Hardware Installation Guide
Action
Copyright © 2006 ADTRAN, Inc.
61202361L2-34D
Advertisement
Table of Contents
