Mitsubishi Electric DLP WD8200LU User Manual page 38

Menu operation (continued)
FEATURE menu (continued)
ITEM
SCART INPUT
LAMP WARNING
HIDE OSD
LAMP 1 TIME RESET OK
LAMP 2 TIME RESET OK
FILTER TIME RESET
RESET ALL
• CINEMA MODE can be adjusted only when a TV60, TV50, 480i, 576i or 1080i signal is being displayed.
• When SCART INPUT is set to ON, normal computer signals aren't projected.
• Use a commercially available SCART-Mini D-SUB 15-pin cable when connecting this projector with an AV device equipped
with the SCART terminal.
• Some AV devices equipped with the SCART terminal aren't compatible with this projector.
• The RESET ALL process may take some time to complete.
• You cannot carry out RESET ALL for approx. 2 minutes after the lamp switching or the lamp relay operation.
SETTING
ON / OFF
STANDARD
SHORT TERM
OFF
ON
OK
OK
FUNCTION
Choose ON when connecting the projector with a device equipped
with the SCART terminal that can output RGB signal. SCART
terminal is used mainly in Europe. Choose OFF normally. (Available
only for the input signal from the COMPUTER/COMPONENT VIDEO
IN-1 terminal.)
When the lamp operating time exceeds 3000 hours with LAMP
MODE set to LOW, a warning dialog is displayed.
When the lamp operating time exceeds 3800 hours with LAMP
MODE set to LOW, a warning dialog is displayed.
Select this option for normal use.
The no-signal dialog, input dialog, SCART warning dialog, auto
power-off dialog, lamp warning dialog, and abnormal temperature
dialog aren't displayed.
The LAMP 1 operation time is reset to 0.
The LAMP 2 operation time is reset to 0.
The filter operation time and the cleaning count is reset to 0.
The menu settings are reset to the factory defaults (except the
LANGUAGE, PASSWORD FUNCTION, IMAGE CAPTURE, and
NETWORK settings).
EN-38