Mitsubishi Electric DLP WD8200LU User Manual page 35

Menu operation (continued)
INSTALLATION 2 menu
ITEM
AUTO POWER ON
AUTO POWER OFF
IMAGE CAPTURE
SPLASH SCREEN
BACK COLOR
DVI LONG CABLE
REMOTE 1 MODE
PIN 1
PIN 2
PIN 3
PIN 4
PIN 5
PIN 6
PIN 7
PIN 8
PIN 9
RESET
FILTER MENU
CLEANUP PERIOD
MANUAL CLEANUP
• You can't set IMAGE CAPTURE and SPLASH SCREEN when PASSWORD FUNCTION in the FEATURE menu has been set to
SPLASH ID SCREEN to enable the password lock.
• When you set BACK COLOR to IMAGE and display the splash screen (startup screen) for a long time of period, the after-image
may remain on the screen. Consult your dealer in this case.
• Don't adjust the lens frequently with BACK COLOR set to IMAGE.
• When STANDBY MODE in the INSTALLATION 1 menu is LOW, you cannot select REMOTE 1 MODE.
1 1
INSTALLATION 2
AUTO POWER ON
AUTO POWER OFF
IMAGE CAPTURE
SPLASH SCREEN
ON
BACK COLOR
DVI LONG CABLE
REMOTE 1 MODE
FILTER MENU
SETTING
ON / OFF
OFF / 5-60min
SETUP
ON / OFF
BLUE / BLACK /
IMAGE
AUTO
MANUAL
ENTER
GND
POWER / NONE
COMPUTER 1
COMPUTER 2
VIDEO
S-VIDEO
DVI
BLANK / NONE
ON/OFF
OK
ENTER
24H / 1 WEEK /
OFF
OK
opt.
2 2
OFF
5min
SETUP
ON
BLUE
AUTO
ENTER
ENTER
FUNCTION
When ON is chosen, the projector is automatically turn on when the power
cord is plugged in the wall outlet. Choose ON when using the projector
mounted on the ceiling.
• The projector is in the stand-by mode when the lamp is off. Use the
remote control to turn on the lamp.
When no video signal is input and no operation is made, the projector
automatically turns off after the selected time period. A dialog is displayed 5
minutes before the projector turns off.
Use to capture the screen for the splash screen. (See page 55.)
Choose ON to display the splash screen when the power is turned on.
• The splash screen can be changed. (See page 55.)
Use to select the background from among BLUE, BLACK and IMAGE, which
will be displayed when there is no signal input from the source. When IMAGE
is selected, the splash screen will be displayed.
Select this option for normal use.
Use to adjust the amount of transmission signal correction when a long DVI
cable is used.
Select when controlling the projector by a control panel connected to the
REMOTE 1 IN terminal. (See page 61.)
Unchangeable. (Fixed.)
Select POWER or NONE.
You can assign COMPUTER 1, COMPUTER 2, VIDEO, S-VIDEO, DVI, HDMI,
or NONE to each pin. Though the assignment can be duplicated, the pins
so assigned become invalid and their settings are displayed with asterisks at
both ends (like "*COMPUTER 1*").
Select BLANK or NONE.
Unchangeable. (Fixed.)
Settings are reset to the defaults.
The filter menu for the following settings is displayed.
You can set the filter cleaning interval. (See page 65.)
Select this option to clean the filter immediately.
EN-35