Advanced Features - Mitsubishi Electric DLP HC910 User Manual

Advanced features

Password function
This projector is equipped with the password function
that is designed for prevention of wrong operation by
children and restriction on operation by other than
specifi ed users.
MENU ACCESS............All the buttons except for the
POWER button on the projector are disabled. (The
buttons on the remote control are enabled.) You can
use this mode as a measure of prevention of wrong
operation by children and restriction on operation
by other than specifi ed users.
To enable the password function:
1. Display the FEATURE menu.
2. Press the or button to select PASSWORD
FUNCTION.
3. Press the ENTER button.
• The screen for setting the password function will
appear.
opt.
MENU ACCESS
LOCK
UNLOCK
• When the password has already been set, the
screen for canceling the password function will
appear.
4. Press the ENTER button.
• The screen for entering a password will appear.
PASSWORD
CONFIRM
O K
5. Press the or button to select a number from 0
to 9.
6. Press the button.
• You can set the next digit.
7. Repeat steps 5 and 6 to set a four-digit password.
8. Enter the password again for confi rmation using the
same steps.
9. Select OK, and press the ENTER button.
• If the entered passwords don't match, an error
message will appear.
• To cancel the procedure, select CANCEL and
press the ENTER button.
• You can cancel the procedure by pressing the
MENU button alternatively.
SVGA60
AV MEMORY 1
OK
OK
CANCEL
To cancel the password function:
1. Display the FEATURE menu.
2. Press the or button to select PASSWORD
FUNCTION.
3. Press the ENTER button.
• The screen for canceling the password function
will appear.
opt.
MENU ACCESS
LOCK
UNLOCK
4. Press the ENTER button.
• The screen for entering the password will
appear.
PASSWORD
O K
5. Press the or button to select a number from 0
to 9.
6. Press the button.
• You can set the next digit.
7. Repeat steps 5 and 6 to enter the four-digit
password.
8. Press the button, select OK, and press the
ENTER button.
• If you enter a wrong password, an error message
will appear.
• To cancel the procedure, press the
select CANCEL, and press the ENTER button.
• You can cancel the procedure by pressing the
MENU button alternatively.
Important:
• If you forget your password, hold down the MENU
and ENTER buttons on the control panel at the
same time about three seconds to cancel the
password function.
SVGA60
AV MEMORY 1
OK
OK
CANCEL
button,
EN-27