Problem Solving Guide; Fault Messages In The Display - Miele T 4662 C Operating Instructions Manual

Problem solving guide

With the help of the following notes, minor faults in the performance of the
appliance, some of which may result from incorrect operation, can be put right
without contacting the Service Department.
,
Repair work to electrical appliances should only be carried out by a
suitably qualified person in accordance with local and national safety
regulations. Repairs and other work by unqualified persons could be
dangerous. The manufacturer cannot be held liable for unauthorised work.

Fault messages in the display

Problem
Locked. Enter code
X
System locked
l
Adjust the load
q
Empty the
container
Possible cause
The lock has been activated. See Settings menu J.
The electronic programme
lock has been activated.
This is not a fault.
The electronic unit has
recognised that there is no
laundry in the drum and
cancelled the programme.
Drying individual garments
or items which are already
dry can also cause the
programme to be cancelled.
The condensed water
container is full or there is a
kink in the drain hose.
Problem solving guide
Remedy
Press and hold the Start/Stop
button until Ready appears in
the display.
Use the Warm air programme
(timed drying) to dry
individual items.
To delete the fault message:
– Open the door or switch
the dryer off and then back
on again.
– Empty out the condensed
water container or check
the drain hose.
To delete the fault message:
– Switch the dryer off and
then back on again.
31