Venting Systems - Miele T 4322 Operating Instructions Manual

= 1 x 3.8 m Additional duct
length
= 2 x 0.8 m Additional duct
length
= 0.5 x 1 m Additional duct
length
= 1 m Additional duct length
Result: A duct diameter of 100 mm is
adequate as the effective duct length is
less than the 20 m specified in Table II.
38
The connection is opened at the
factory.
^ Fit one of the venting systems
described on the following pages.
= 3.8 m
= 1.6 m
= 0.5 m
^ Remove the left or right hand side
cover cap. Do not remove the frame.
= 1.0 m
Refit it in the rear outlet.
= 6.9 m
^ Ensure it is securely in position so
that it cannot fall out when the dryer
is in operation.
^ Fit one of the venting systems
described on the following pages.