Miele T 4322 Operating Instructions Manual page 17

F
^ Press the Start button.
The drying cycle begins.
The drying stage reached is shown by
the sequence indicator lamps on the
right hand side of the control panel.
At the end of the drying phase a
cooling down phase commences to
cool the laundry down. The Cool air
indicator lights up.
The required degree of dryness has
now been reached.
G
When the drying programme has
finished the Anti-crease/Finish indicator
lamp and the indicator lamp for the
drying stage reached will come on.
0 will then appear in the display.
The anti-crease phase will start at the
end of the programme, and the drum
will continue to rotate at intervals to
prevent laundry creasing, if you do not
wish to remove it immediately. You can
remove the laundry at any time during
the anti-crease phase.
The buzzer will sound at intervals
during the anti-crease phase if it has
been selected.
^ Press the Door button to open the
drum door.
^ Remove the laundry.
Make sure that the drum is empty. If
items are left in the dryer, they could
be damaged by overdrying when
the dryer is next used.
^ After every cycle remove the fluff
from the fluff filter in the door (see
"Cleaning and Care").
^ After each use, switch the dryer off
by pressing the l-On / 0-Off button.
^ Always close the door after use.
Clean out airways
This indicator lamp comes on to warn
you that the dryer is not working
efficiently.
This may be because:
– the fluff filter in the door is blocked;
– the vent ducting or the ventilation
outlet is blocked;
– the vent ducting is very long
(see "Installation - venting" for notes
on duct length and diameter).
If it is not possible to shorten the vent
ducting, the Clean out airways
indicator lamp will remind you after
each drying cycle that the fluff filter
needs to be cleaned.
17