Buzzer - Miele G 1270 Operating Instructions Manual

Operation

Buzzer

A buzzer sounds at the end of the
programme or if there is a fault.
You will hear the buzzer at the end of a
programme in bursts of five with a short
pause in between. The buzzer will
continue to sound for up to an hour if
you do not switch the dishwasher off.
In the event of a fault, the buzzer will
sound continuously for up to two
minutes if you do not switch the
dishwasher off or correct the fault.
The buzzer is activated as standard at
the factory.
You can deactivate the buzzer at the
end of a programme if you wish. The
buzzer will still sound if there is a fault,
even if it has been deactivated.
^ Open the door.
^ Switch the dishwasher off using the
Off button o.
^ Press the programme selector button
in, and whilst holding it in switch
the dishwasher on using the On
button g.
Keep the programme selector button
pressed in for at least four seconds
until the lower right hand programme
indicator comes on.
If this does not happen, start the
procedure from the beginning again.
38
^ Press the Tab button four times.
The "3 in 1 Tab" indicator will flash
briefly four times at intervals.
The characters flashing in the Display
show whether the buzzer at the end of
the programme is activated or
deactivated.
– "p 1": the buzzer is activated
– "p 0": the buzzer is deactivated
^ To change the setting, press the
programme selector button.
The setting is now stored in memory.
^ Switch the dishwasher off using the
Off button o.