Adjust Sensor Wash - Miele G 1270 Operating Instructions Manual

Operation

Adjust sensor wash

You can adjust the sensor wash
programme so that it will remove
stubborn soiling in a lightly soiled load.
^ Open the door.
^ Switch the dishwasher off with the Off
button o.
^ Press the programme selector button
in, and whilst holding it in switch
the dishwasher on using the On
button g.
Keep the programme selector button
pressed in for at least four seconds
until the lower right hand programme
indicator comes on.
If this does not happen, start the
procedure from the beginning again.
^ Press the Tab button five times.
The "3 in 1 Tab" indicator will flash
briefly five times at intervals.
40
The characters flashing in the Display
show whether the "Adjust sensor wash"
function is activated or deactivated.
– "p 1": The "Adjust sensor wash"
function is activated.
– "p 0": The "Adjust sensor wash"
function is deactivated.
^ To change the setting, press the
programme selector button.
Switch the dishwasher off with the Off
button o.