Setting The Rinse Aid Dosage - Miele G 1182 Operating Instructions Manual

Before using for the first time

Setting the rinse aid dosage

You can adjust the rinse aid dosage for
best results.
The rinse aid dosage can be set from
approx. 0-6 ml. It is set to a
recommended setting of approx. 3 ml
at the factory.
If spots appear on crockery and
glassware:
^ Increase the rinse aid dosage.
If clouding or smearing appears on
crockery and glassware:
^ Decrease the rinse aid dosage.
^ Switch the dishwasher off with the Off
button V.
^ Press the programme selector button
in, and whilst holding it in switch
the dishwasher on using the On
button U .
Keep the programme selector button
pressed in until the lower right hand
programme indicator comes on.
If this does not happen, start the
procedure from the beginning again.
^ Press the programme selector button
three times briefly.
The "Inlet/Drain" check light will flash
briefly three times at intervals.
22
The upper right hand programme
indicator will flash briefly three times at
intervals.
This means that approx. 3 ml of rinse
aid will be used per programme
(factory default setting).
The number of times the upper right
hand programme indicator flashes tells
you the water hardness level which has
been set (see chart).
Rinse aid
in ml
0
1
2
3
4
5
6
^ Press the programme selector button
for at least one second until the
"Inlet/Drain" check light comes on.
^ Press the programme selector button
briefly to select the number of flashes
which equate to the rinse aid dosage
you want.
Each press on the button moves you
up a level.
The programmed rinse aid dosage is
now stored in memory.
^ Switch the dishwasher off with the Off
button V.
Flashing frequency
-
Once
Twice
Three times
Four times
Five times
Six times