Electrical Connection - Miele M 637 EC Operating Instructions Manual

Table of Contents

Advertisement

Before connecting the appliance,
ensure that it has not been damaged
in any way. Do not use a damaged
appliance.
All electrical work should be carried out
by a suitably qualified and competent
person in strict accordance with
national and local safety regulations.
The appliance is supplied with a cable
and moulded plug ready for connection
to a 230-240 V/50 Hz a.c. single phase
supply.
The voltage, rated load and fusing are
given on the data plate which is located
externally on the rear wall of the
appliance. Please ensure that these
match the household mains supply.
Connection should be made via a fused
connection unit or a fused plug and a
suitable switched socket, or via a
suitable isolator, which complies with
national and local safety regulations,
and the on/off switch should be easily
accessible after the appliance has
been installed.
If the socket is not accessible after
installation (depending on country) an
additional means of disconnection must
be provided for all poles.
When switched off there must be an
all-pole gap of 3 mm in the isolator
switch (including switch, fuses and
relays acc. to EN 60335).
For extra safety it is advisable to install
a residual current device with a trip
current of 30 mA (in accordance with
DIN VDE 0664, VDE 0100 Section 739).
If the appliance is connected via an
isolator switch the plug must be cut off
and rendered useless.
The wires in the mains lead of this
appliance are coloured in accordance
with the following code:
As the colours of the wires in the mains
lead of this appliance may not
correspond with the markings
identifying the terminals in your plug,
proceed as follows:
The wire coloured green and yellow
must be connected to the terminal in
the plug which is marked with the letter
E or by the earth symbol z or coloured
green or green and yellow.
The wire coloured blue must be
connected to the terminal marked with
the letter "N" or coloured black. The
wire coloured brown must be
connected to the terminal marked with
the letter "L" or coloured red.
47

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents