Fitting The Front Facia Panel / Lightshield - Miele DA 262 i Operating Instructions Manual

Installation
Installation
2
Pull out the snap fittings from the
slots on the left and right hand sides
of the deflector plate (1).
Press the baffle (2) into the engaging
point. Put the snap fittings back in
place.
The snap fitting with the hole must
be inserted on the right.
Do not wipe off any lubricant.
Hold the template supplied against
the back of the lightshield and mark
the drill hole positions for fixing the
hinges.
20
1
Only use the template for lightshields
with the following lengths:
DA 262 i
b
598 mm
c
597 mm
d
596 mm
e
595 mm
f
599 mm
With other lengths adjust the measure-
ments accordingly.
Fitting the front facia panel /
lightshield
1
Screw the hinges (2) supplied to the
left and right hand sides of the front
facia panel / lightshield (1).
With the Miele aluminium lightshield the
screws are supplied.
For lightshields with a Miele kitchen fur-
niture programme use 3.5x16mm
screws supplied.
Hold the front facia panel / light-
shield against the deflector plate:
the holes in the hinges must lie over
the holes visible in the deflector
plate (3).
Use an allen key to screw in the (4)
screws from accessory kit on each
side.
DA 272 i DA 292 i
698 mm 898 mm
697 mm 897 mm
696 mm 896 mm
695 mm 895 mm
699 mm 899 mm
2 3
4