Attaching The Front Panel; Aligning The Deflector Plate; Fitting The Grease Filter - Miele DA 3466 Operating And Installation Instructions

Installation

Attaching the front panel

The front of the deflector plate can be
fitted with a front panel to match
existing kitchen furniture units.
The front panel must not exceed
1300 g. This applies to front panels with
a depth of up to 30 mm. For larger and
heavier front panels, the weight must be
reduced by e.g. machining it away at
the back.
A DML 400 installation kit, available as
an optional accessory, is required for
this.
 Follow the installation instructions
supplied.
36

Aligning the deflector plate

The position of the deflector plate can
be brought forward by up to 35 mm
using the adjusting screws on either
side of the deflector plate. This allows
the deflector plate to be aligned to the
front of the kitchen furniture units on
either side.
 Use a screwdriver to align the
deflector plate correctly.

Fitting the grease filter

 Remove the protective foil around the
edge of the grease filter.