Related Manuals for Miele DA 2660
Summary of Contents for Miele DA 2660
- Page 1 Operating and installation instructions Rangehood To prevent the risk of accidents or damage to the appliance, it is essential to read these instructions before it is installed and used for the first time. en-AU, NZ M.-Nr. 10 352 140...
-
Page 2: Table Of Contents
Contents Warning and Safety instructions................ 4 Caring for the environment ................ 13 Description of the functions ................ 14 Con@ctivity 2.0 function..................15 Guide to the appliance .................. 16 Operation (automatic mode) ................ 18 Cooking with Con@ctivity 2.0 (automatic mode) ..........18 Leaving automatic mode temporarily .............. - Page 3 Contents Safety distance (S) ....................38 Installation recommendations ................39 Connection for air extraction ................ 40 Silencer........................41 Electrical connection .................. 43 Activating Con@ctivity 2.0 .................. 44 Installing the Con@ctivity 2.0 dongle ..............44 Activating Con@ctivity 2.0..................44 Activating the rangehood ................. 44 Activating the cooktop ..................
-
Page 4: Warning And Safety Instructions
It must only be used to extract vapours and remove odours from cooking. Any other usage is at the owner's risk. Miele cannot be held liable for damage resulting from incorrect or improper use or operation. Where a recirculation rangehood is fitted above a gas cooktop, please ensure that there is an adequate supply of fresh air into the room in which it is installed. - Page 5 Warning and Safety instructions This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning its use by a person responsible for their safety, and are able to recognise the dangers of misuse.
-
Page 6: Technical Safety
Repairs and other work by unqualified persons could be dangerous. Installation, maintenance work and repairs to electrical appliances must only be carried out by a Miele approved service technician. A damaged appliance can be dangerous. Check it for visible signs of damage. - Page 7 Miele replacement parts are used. If the mains connection cable is damaged, it must only be replaced by a Miele authorised service technician in order to avoid a hazard. During installation, maintenance and repair work, the appliance must be disconnected from the mains electricity supply.
- Page 8 Warning and Safety instructions Using at the same time as other heating appliances that depend on the air from the room Warning - danger of toxic fumes Great care should be taken when using the rangehood at the same time and in the same room or area of the house as another heating appliance which depends on the air in the room.
- Page 9 Warning and Safety instructions In order to ensure safe operation, and to prevent gases given off by the heating appliances from being drawn back into the room when the rangehood and the heater are in operation simultaneously, an underpressure in the room of 0.04 mbar (4 pa) is the maximum permissible.
-
Page 10: Correct Use
Warning and Safety instructions Correct use Never use an open flame beneath the rangehood. To avoid the danger of fire, do not flambé or grill over an open flame. When switched on, the rangehood could draw flames into the filter. Fat deposits could ignite, presenting a fire hazard. -
Page 11: Correct Installation
Warning and Safety instructions Do not use the rangehood without the filters in place. This way you will avoid the risk of grease and dirt getting into the appliance and hindering its smooth operation. The rangehood can get very hot during cooking due to heat rising from the cooktop. -
Page 12: Cleaning And Care
Accessories Use only genuine original Miele spare parts. If spare parts or accessories from other manufacturers are used, the warranty will be invalidated, and Miele cannot accept liability. -
Page 13: Caring For The Environment
Caring for the environment Disposal of the packing Disposing of your old material appliance The transport and protective packing Electrical and electronic appliances has been selected from materials which often contain materials which, if are environmentally friendly for handled or disposed of incorrectly, disposal, and can normally be recycled. -
Page 14: Description Of The Functions
(...EXT model rangehoods) Rangehoods set up for operation with an external motor have to be connected to a Miele external motor located in a suitable position outside the room in which the rangehood is installed. The external motor is linked to the rangehood via a connection cable and then operated via Con@ctivity 2.0 or... -
Page 15: Con@Ctivity 2.0 Function
Miele and, then after a short time, the fan electric cooktop. also comes on. – During cooking the rangehood... -
Page 16: Guide To The Appliance
Guide to the appliance... - Page 17 (DA 2660, DA 2690 only) d Grease filters (DA 2660, DA 2690: 2 filters; DA 2620: 4 filters) e Edge extraction panel (DA 2660, DA 2690: 1 panel; DA 2620: 2 panels) f Touch controls g Touch control for the cooktop lighting...
-
Page 18: Operation (Automatic Mode)
Operation (automatic mode) If Con@ctivity 2.0 is activated, the Reaction time rangehood always operates in The rangehood reacts with a slight automatic mode (see "Activating delay because altering the power Con@ctivity 2.0"). setting on the cooktop does not To operate the rangehood manually, see immediately result in a reduction or "Cooking without Con@ctivity 2.0 increase in cooking vapours. -
Page 19: Switching Off
Operation (automatic mode) Cooking process Switching off If, for example, you switch on a Switch off all cooking zones. cooking zone at the highest power The rangehood fan will reduce its power setting to heat a pan for frying and level over the next few minutes and will reduce the power level after approx. -
Page 20: Leaving Automatic Mode Temporarily
Operation (automatic mode) Leaving automatic mode Returning to automatic mode temporarily The rangehood returns to automatic mode: To leave automatic mode temporarily during cooking: if the rangehood has not been used for approx. 5 minutes after selecting a Manually select a different power power setting manually, or setting, or ... -
Page 21: Operation (Manual Mode)
Operation (manual mode) With the run-on function the fan Cooking without Con@ctivity switches itself off automatically after a 2.0 (manual mode) pre-selected time. The rangehood can be operated After you have finished cooking, manually if: press the run-on function touch –... -
Page 22: Power Management
Operation (manual mode) To switch it on, press "". Power management The 1 and IS indicators will light up The rangehood features a Power constantly. management system to help save energy. The fan power setting is Confirm the setting by pressing the reduced and the lighting is switched off run-on control 5 15. -
Page 23: Operation (Automatic And Manual Modes)
Operation (automatic and manual modes) Fan power setting indicators 1 to IS Operating hours counter show the time set: The number of hours the appliance has 1..........20 hours been in operation is stored in memory. 2..........30 hours When the grease filter symbol or the charcoal filter symbol ... -
Page 24: Activating And Altering The Operating Hours Counter For The Nosmell Active Charcoal Filters
Operation (automatic and manual modes) Activating and altering the operating Reading the filter operating hours hours counter for the NoSmell active counter charcoal filters To check the percentage of time set Charcoal filters are needed for already used: recirculation mode. ... -
Page 25: Energy Saving Tips
Energy saving tips This rangehood operates very efficiently – Make sure that you switch the and economically. The following will rangehood off after use. help you to save even more energy If cooking vapours and odours still when using it: need to be removed from the kitchen air after cooking, use the –... -
Page 26: Cleaning And Care
Switch the fan off before any cleaning proprietary conditioning agent for or maintenance work is carried out. stainless steel (Original Miele Care All external surfaces and controls can product for stainless steel) can also be cleaned using warm water with a be used. -
Page 27: Grease Filters And Edge Extraction Panel
Cleaning and care Important for the controls Grease filters and edge extraction panel Do not leave soiling on the controls for any length of time. The edge extraction panel and the re- Otherwise they may suffer usable metal grease filters in the discolouration or damage. - Page 28 Cleaning and care Removing the panel and grease filters The panel and grease filter can fall out when you are handling them. This can result in damage to the filters, panels and the cooktop below. Make sure you hold the panel and the grease filters securely at all times when handling them.
- Page 29 Cleaning and care Cleaning the panel(s) by hand Cleaning the panel(s) and the grease filters in the dishwasher Follow the instructions under Place the panel(s) and the filters "Housing". upright or slightly inclined in the lower Cleaning the grease filters by hand basket, with the short sides upright, ensuring the spray arm is not ...
- Page 30 Cleaning and care After cleaning After cleaning, leave the filters to dry on an absorbent surface before refitting them. When removing the filters and panel for cleaning, also clean off any residues of oil or fat from the now accessible housing to prevent the risk of these catching fire.
-
Page 31: Nosmell Active Charcoal Filters
for approx. 3 seconds until only the 1 is Charcoal filters are available from Miele. flashing. You will need to order a DKF 19-1 filter The grease filter symbol goes out. -
Page 32: Resetting The Operating Hours Counter For The Charcoal Filters
Cleaning and care Fitting and replacing the charcoal When to change the NoSmell active filters charcoal filters Before fitting or replacing the Always replace the charcoal filters charcoal filters, the panel and the when they no longer absorb kitchen grease filters must first be taken out odours effectively. -
Page 33: Installation
Installation The rangehood is intended to be built Before installation into wall units, rangehood housing Before installation, it is important units, and above breakfast bars or to read the information given on the island areas. following pages as well as the ... -
Page 34: Assembly Parts
Installation Assembly parts... - Page 35 Installation a 1 exhaust socket for exhaust ducting 150 mm. b 1 reducing collar for exhaust ducting 125 mm (recommended for connection to existing 125 mm ducting only). c 1 non-return flap for fitting into the exhaust socket on the motor unit 4 x M5 x 40 mm screws, 4 washers, 4 (not needed for recirculation mode).
-
Page 36: Appliance Dimensions
Installation Appliance dimensions... - Page 37 Installation...
-
Page 38: Safety Distance (S)
Installation a The ducting can also be connected at the back. b 222 x 89 mm flat exhaust ducting can be used as an alternative for ducting to the rear or to the side. c The rangehood is secured in the cut-out by clamps. This requires that the installation surface is made of a solid material, such as wood. -
Page 39: Installation Recommendations
Installation Installation recommendations – If positioned too high, extraction will be inefficient. – To achieve optimum vapour extraction, the rangehood must cover the cooktop. It should be positioned centrally over the cooktop, not to the side or to the rear. –... -
Page 40: Connection For Air Extraction
Connection for air extraction – A reduction in diameter will Before installation, it is important compromise the extraction to read the information given on the performance of the rangehood. following pages as well as the "Appliance dimensions" and the –... -
Page 41: Silencer
Connection for air extraction When ducting is horizontal it must be Silencer laid to slope away at at least 1 cm per metre. This is to ensure that condensate cannot drain back into the rangehood. If the exhaust ducting is to run through rooms, ceiling space etc. - Page 42 Connection for air extraction Recirculation mode The silencer needs to be positioned between the exhaust connection and the exhaust grille . Ensure there is adequate space for fitting it. Air extraction with external motor To minimise noise from the motor in the kitchen, the silencer should be positioned in front of the external motor ...
-
Page 43: Electrical Connection
Electrical connection All electrical work should be undertaken by a suitably qualified and competent person in strict accordance with current national and local safety and building code regulations. Installation, repairs and other work by unqualified persons could be dangerous, for which the manufacturer cannot be held liable. -
Page 44: Activating Con@Ctivity 2.0
Activating Con@ctivity 2.0 Activating the rangehood Installing the Con@ctivity 2.0 dongle The cooktop and rangehood must be switched off. In order for the Con@ctivity 2.0 function to be used, the cooktop must be fitted Press the run-on option control 515 with the Con@ctivity dongle. -
Page 45: Activating The Cooktop
Activating Con@ctivity 2.0 Activating the cooktop Activation failed While the rangehood is searching for If connection cannot be established the radio connection, start activating despite activating the Con@ctivity the cooktop. function on the rangehood and More information about this can be cooktop, the function must be found in the Operating instructions deactivated on both appliances and... -
Page 46: After Sales Service And Warranty
After sales service and warranty In the event of a fault which you cannot remedy yourself, please contact Miele. The contact details for Miele are given at the back of these instructions. When contacting Miele, please quote the model and serial number of your appliance. -
Page 47: Technical Data
* For EXT models, the rated load and extraction power will depend on the type of external motor fitted. Length of connection cable to external motor: 1.9 m Recirculation mode (DA 2660 and DA 2690 only) with Charcoal filter set DKF 19-1. Contains two charcoal filters. - Page 51 Freemans Bay, Auckland 1011 Miele Experience Centre South Melbourne: 206-210 Coventry Street Miele Experience Centre South Melbourne, VIC 3205 Auckland: Miele Experience Centre and Office Sydney: 8 College Hill 3 Skyline Place Freemans Bay, Auckland 1011 Frenchs Forest, NSW 2086 Telephone:...
- Page 52 DA 2660 DA 2690 DA 2620 DA 2660 EXT DA 2690 EXT DA 2620 EXT en-AU, NZ M.-Nr. 10 352 140 / 00...