Spinning
The maximum final spin speed
depends on the programme chosen.
Programme
Cottons
Minimum iron
Delicates
Silks
Woollens
Express
Automatic
Dark garments
Shirts
Denim
Sportswear
Outerwear
Proofing
Curtains
Separate rinse
Starch
Drain/Spin
You can reduce the final spin speed.
However, you cannot select a final spin
speed higher than that shown in the
chart above.
Rinse and interim spin
There is a spin after the main wash and
between the rinses. A reduction in the
final spin speed will also reduce the
interim spin speed. If a spin speed of
less than 700 rpm is selected for a
Cottons programme, an additional rinse
is introduced.
To omit the final spin (Rinse hold)
^ While the spin speed is highlighted in
the display, press the minus (-) button
repeatedly to call up the Rinse hold
rpm
setting and then press OK to confirm
1600
your selection.
1200
The laundry will not be spun and will
600
remain suspended in the final rinse
400
water. This reduces creasing if the
laundry is not going to be removed
1200
from the drum immediately after the
1600
end of the programme.
1200
1200
– To start the final spin:
600
The machine will display the
900
maximum spin speed possible. You
1200
can select a spin speed lower than
800
this. Start the final spin by pressing
the Start/Stop button.
1000
600
– To end the programme:
1200
Press the Door button. The water will
1500
drain away. Press the Door button
1600
again to open the door.
To omit rinse and interim spin and
the final spin
^ While the spin speed is highlighted in
the display, press the minus (-) button
repeatedly to call up the Without spin
setting and then press OK to confirm
your selection.
The laundry is not spun after the final
rinse. The water will drain away and
the machine will go straight into the
anti-crease stage. An additional rinse
is introduced if this setting is selected
with the Cottons, Minimum iron,
Express and Automatic programmes.
WASHING
23
Need help?
Do you have a question about the WT 2679 WPM and is the answer not in the manual?